Put a transmitter into operation
a) Insert Accumulators
Open the accumulator compartment and the bottom side by pressing the two wings of
the accumulator cover on the back side of the transmitter downwards and at the same
time pull it out to take off the accumulator compartment cover.
Now you can take out the accumulator retainer and insert 8 Mignon/AA accumulators
with special caution of the correct polarity (observe plus/+ and minus/-) If you plug out
the accumulator retainer, observe the plug type when plugging in, do not use force
when plugging together.
Insert the accumulator back in the accumulator compartment. Make sure that the
connection cable is not bent or pinched.
Push the accumulator compartment cover open, until it snaps.
The transmitter has an integrated warning buzzer that sounds, when the vol-
tage of the accumulator package during operation decreases to 9.5V.
If the warning signal buzzes during the flight, immediately begin landing and
stop flight operation.
Exchange the batteries with new ones afterwards.
The running time of the transmitter is dependent of the accumulator capaci-
ty and the condition of the accumulators.
120
Figure 2