Measuring Parameters - ECOLAB MULTRONIC Bedienungsanleitung

The max. metering time function is used to specify the period of time during which the
controller may meter uninterrupted before the alarm message 'metering time exceed'
appears and the controller is turned off. This alarm message can be acknowledged
with ENTER. The controller then resumes operating until the metering time may be
exceeded again. The metering time monitoring function of other possible controllers
also remains unaffected if an alarm is indicated. Where required, these are also turned
off once they have reached their max. metering time.
Value range: 10 sec to 9999 sec
The metering time monitoring function can be turned off with the Off setting.
NOTE
Through selecting the module selection function one returns to configuration module
selection.
The first page of the pH module configuration menu is opened through selecting page 1.
4.2

Measuring parameters

The main menu for adjusting the Multronic is accessed through operating the ↑ key in
the measuring mask.
Main menu
The measurement parameters are selected through placing the cursor onto the
selected item and operating the ENTER key.
Measurement
parameter module
selection
(not available at
Multronic OC!)
The pH measuring module that is to be parametered can now be selected. To do so,
move the cursor onto the corresponding selected item and operate the ENTER key.
The following measurement parameters can be adjusted for the pH measuring module.
Measurement
parameter (pH)
The measuring range function is used to change the measuring range.
Value range: 0..14 pH / 2..12 pH / 3..8 pH
417101804_Anhang03_pH.doc
The time periods for the controllers must be within realistic limits.
min. controller on-time < controller cycle time < max. metering time
pH Measuring Module
- 38 - Rev.: 07-07/10