To Recall Wave File From Oscilloscope - PeakTech 4125 Bedienungsanleitung

5.44. To recall wave file from Oscilloscope

This function can read the waveform file with suffix of (*.ota) which is cut from PeakTech®
oscilloscopes and saved to USB device or cut by the software of the oscilloscopes. Then
ARB waveform generators can output the same signal as the cut wave.
Compatible Oscilloscope-models:
PeakTech 1240
PeakTech 1245
PeakTech 1255
PeakTech 1260
PeakTech 1270
PeakTech 1275
Use one of these oscilloscopes to cut wave:
- Connect USB device to the oscilloscope.
- Press
Save
- Press the H1 button, the Type menu will display at the left of the screen, turn the
"M"-knob to choose
- Move cursor1 and cursor2 to choose the range of wave to be cut.
Press the "H2"-button, and the input keyboard will pop up. The default name is the
-
current system date. Turn „M"-knob to choose the keys, and press "M"-knob to
input the chosen keys. Choose and press
input and store the file with the current name to USB device.
Use waveform generators to recall wave:
Enter the operation menu: Press
to call out the save menu.
for type.
Cut Wave
Figure 0-24: Cut Wave
key of the keyboard to end the
Enter
→Editable Wform →SelectWform.
-91-