User Interface - PeakTech 4125 Bedienungsanleitung

4
Modulation In
5 RS232 port
6 Power socket
7 Fuse
8 Power switch
9 USB Host port
10 USB Device port

4.3. User Interface

1 Current channel
2 Parameter 1, display parameter and edit the focused parameter
3 Current signal type or mode
4 The setting menu of current signal or mode
5 Parameter 3, display parameter and edit the focused parameter
6 Parameter 2, display parameter and edit the focused parameter
7 Display current waveform
8 Offset/low level, depends on the highlighted menu item on the right
9 Amplitude/high level, depends on the highlighted menu item on the right
10 Frequency/period, depends on the highlighted menu item on the right
11 Load, High Z represents high resistance
Modulation waveform input, use it as external signal
source
Through this interface, the generator can be
connected to a PC and controlled via PC software
AC input connector
Use the specified fuse according to the voltage scale.
Switch between 110V and 220V.
Connect as a "host device" with an external USB
device, such as connect a USB disk to the instrument.
Connect as a "slave device" with an external device,
such as connected to a PC and controlled via PC
software.
Figure 0-3 User interface (take Sine for instance)
-62-