To Use Usb Storage; To Edit The File Name; To Set The Utility Function - PeakTech 4125 Bedienungsanleitung

5.41. To Use USB Storage

The storage location is divided into the internal storage (FLASH) and the U disk storage
(USBDEVICE). When a U disk is connected, the storage menu will show "USBDEVICE"
and "FLASH". Otherwise, the storage menu will show "FLASH" only.
1. Install the U disk: insert a USB disk into the "⑨USB Host port" on the rear panel in
Abb 0-2; and the screen will show "Detect USB device". Press Save function button to
enter the file system, the storage menu will show "USBDEVICE" and "FLASH".
2. Enter the storage: Turn the knob or press
desired storage. Press F1 to enter the chosen storage. Provide operations as Next
level, Up one level, New folder, Delete, Rename, Copy, Paste.
3. Remove the U disk: Remove the U disk from the USB Host port on the rear panel.
The system will inform you "The USB device is removed", and the "USBDEVICE" in
the storage menu will disappear.

5.42. To Edit the File Name

In file system, the user can edit the name of a file or a folder. When the system needs the
user to input a name, an input keyboard will appear.
1. Turn the knob or press
keyboard. Press F3 to switch between capital and small of the characters.
2. Press F1 to enter the current character. Press F2 to delete the last character .
3. Press F4 to finish editing and save the file. Press
operation.
Note: The length of file name is up to 15 characters.

5.43. To Set the Utility Function

Press Utility function key to enter the Utility Menu. You can set the parameters of the
Generator such as: Display Parameter, Counter Parameter, Output Parameter and
System Setting. Press Utility again to exit the Utility Menu.
Figure 0-23: Edit the File Name
/ direction key to move the cursor left and right in the
-90-
/ direction key to choose the
F5 to cancel the save