To Set The Beep; View System Information - PeakTech 4125 Bedienungsanleitung

Sweep
Start/Stop Frequency
Time
Mode
Burst
Frequency
Count
Period
Phase
Others
Brightness
Separator
Screen Saver time
Baud Rate
Load
Phase Deviation
Clock Source
Channel Output Control

8.4. To Set the Beep

1. Press Utility and choose System, enter the second page of the menu.
2. Press F1 to select Beep.
3. Press F1 to switch between On/Off. On is to activate the sound when the system
informs you. Off is to deactivate it.

8.5. View System Information

1. Press Utility and choose System, enter the second page of the menu.
2. Press F2 to select Sys info. You can view the Version and Serial number.
Default
100Hz/1kHz
1 sec
Linear
Default
1kHz
1 Cycle
1 sec
0°
Default
95%
Comma
100 minutes
115.2K
High Z
0°
Internal
Off
-98-