To Set Pulse Width / Duty Cycle; To Output Noise Signals - PeakTech 4125 Bedienungsanleitung

5.14. To Set the Pulse Width / Duty Cycle
(1) Press F4 button, the chosen menu item is highlighted, the focused parameter is
displayed in Parameter 1. Press F4 to switch between Pulse Width/Duty.
(2) Turn the knob to change the value directly;
or press the number keys to input the desired value and choose the unit.

5.15. To Output Noise Signals

The noise signal which the generator output is white noise. Press
user interface of Noise signal, the Noise waveform parameters can be set by operating the
Noise setting menu on the right.
The parameters of Noise waveform are: Amplitude/High Level, Offset/Low Level. You can
operate the menu by using the menu selection buttons on the right.
To set the Amplitude/High Level, Offset/Low Level, please refer to "To Output Sine
Signals" on page 67.
Figure0-12: Set the Pulse Width of Pulse signal
Figure 0-13: The User Interface of Noise Signal
-73-
button to call the