PeakTech 4125 Bedienungsanleitung Seite 93

1. When the output signal is Sine, Square, Ramp, Pulse or Arbitrary waveform, press the
Mod button, then press F3 to select Burst.
2. Press ,
instance, press
parameters, please refer to "To Set signals" on page 67. Press
return to the Burst mode interface.
3. Press F3 to switch to N Cycle.
4. Press F1 to select Burst Period, set it to the desired value.
5. Press F2 to select Start Phase (if current waveform is Pulse, skip this step), define
the Start and the Stop Point in a waveform. The phase varies from -360° to +360°. For
an Arbitrary Waveform, 0° is the first waveform point.
6. Press F4 to select Cycles or Infinite. Set the number of Waveform Cycle in an
N-Cycle (from 1 to 50,000). If you choose Infinite, then a continuous waveform will be
generated which will not stop until a trigger event happens (the knob on the front
panel is pressed).
Note:
● If needed, Burst Period will increase to cater to the specific number of cycles.
● For an infinite-cycle Burst, External or Manual Trigger is needed to activate burst.
7. Press F5
External means using the Ext Trig/FSK/Burst connector in the rear panel to input
the external signal. Manual means choosing manual trigger; in N-Cycle Burst
interface, press the knob on the front panel to output a burst signal.
, , or
to display the waveform and parameters. You can change the
to select the source. Internal means using the internal source.
button to choose the waveform. Take Sine for
-88-
button again to