Rear Panel - PeakTech 4125 Bedienungsanleitung

12
CH1 Output
Control
13 CH1 Output
14
CH1/2 button
15 Modulation (Mod)
16 Both button
17 Waveform
selection buttons
18 Power button

4.2. Rear Panel

1 20MHz reference output
2 20MHz reference input /
Counter input
3 External Trigger
/FSK/Burst
Turn on/off the output of CH1. The backlight will be lighted
when CH1 is tuned on.
Output signal of CH1
Switch channel displayed on the screen between CH1 and
CH2.
Generate the Modulated waveforms, Sweep and Burst;
these functions are only used for CH1.
Display the editable parameters of both channels. When the
function is enabled, the backlight of the button turns on.
Include: Sine
Noise
waveform is selected, the backlight of the button turns on.
Turn on/off the generator
① ② ③
⑩
Figure 0-2 Rear panel overview
These two connectors are used to synchronize
generators.
accepts an external 20 MHz clock signal, and the
connector [20MHz Out] can output a 20 MHz clock
signal generated by the crystal inside the generator.
("To set the clock source"; page 96)
The connector [20MHz In/Counter] is also used to
accept the input signal of counter. ("To set the
counter"; page 91)
This signal can be used as external signal source in
Sweep, FSK and Burst mode.
, Square
and Arbitrary
④ ⑤
⑨
The connector
-61-
, Ramp , Pulse
waveform. When a
⑥
⑦
⑧
[20MHz In/Counter]
,