Set The Gated Burst; To Save And Recall - PeakTech 4125 Bedienungsanleitung

5.39. Set the Gated Burst

1. When the output signal is Sine, Square, Ramp, Pulse or Arbitrary waveform, press
the Mod button, then press
2. Press ,
Sine for instance, press
change the parameters, please refer to "To Set signals" on page 67. Press
button again to return to the Burst mode interface.
3. Press F3 to switch to Gated.
4. Press F2
waveform. The phase varies from -360° to +360°. For an Arbitrary Waveform, 0° is
the first waveform point.
5. Press F5 to switch between Positive/Negative. Set the Polarity for the Gated
Signal.

5.40. To Save and Recall

Press Save function button to enter the file system.
Figure 0-22: The User Interface of Gated Burst
F3 to select Burst.
, , or
to display the waveform and parameters. You can
to select Start Phase, define the Start and the Stop Point in a
button to choose the waveforms. Take
-89-