Cocraft MB1931-UK Bedienungsanleitung Seite 17

The machine 1. The electric cable is not
will not start.
2. Damaged fuse.
3. Motor broken down.
4. Loose cables.
5. The motor cover is loose.
6. The motor will not start.
The fuse cuts 1. The extension cable is too
out repeatedly.
2. The planing irons are blunt.
3. Low voltage.
The wood is 1. Planing table is dirty.
not fed forward
2. The feeding roll is
properly.
3. Chain collar is damaged.
4. The gears are damaged.
Work piece 1. The planing iron is set
gets stuck.
plugged in.
long or too thin.
damaged.
vertically incorrect.
17
1. Check power supply.
2. Check the fuse and change
if need be.
3. Check motor.
4. Leave machine into
customer service to be
looked at.
5. Allow machine to cool down
and then restart.
6. Leave machine into
customer service to be
looked at.
1. Use a shorter or thicker
extension cable.
2. Sharpen or change
the planing irons.
3. Check voltage.
1. Clear shavings and rubbish
off planing table off.
Grease the planing table if
need be.
2. Change feeding roll.
3. Change chain collar.
4. Check gears.
1. Adjust the planing iron to
correct height.