Screw Mounting - HomeMatic HM-TC-IT-WM-W-EU Bedienungsanleitung

are mounting the room thermostat must be clean, dry
and free of grease.
• For mounting of the assembled room thermostat, attach
the adhesive strips to the back side of the mounting
plate (K). You should be able to read the letters on the
back side (according to figure).
• Remove the protective film from the adhesive strips.
• Press the assembled room thermostat with the back side
to the wall in the position where it should subsequently
be attached.

8.3.2 Screw mounting

• Choose a site for installation.
• Make sure that electrical lines in the wall will not be
damaged.
• Position the mounting plate (K) on the desired site on
the wall. Make sure that the arrow on the mounting plate
is pointing upwards.
• Use a pen to mark the positions of 2 bore holes 1 (di-
agonally opposite) in the mounting plate (K) on the wall.
The bore holes 2 can be used for installation with a
flush-mounting box.
<PA66>
Start-up
53