Initial Operation; Fitting/Changing The Saw Blade; Fitting The Guide Fence; Connecting The Sawdust Extraction Appliance - Parkside PSTK 800 B2 Originalbetriebsanleitung

Initial operation

Fitting/changing the saw blade

Always remove the plug from the power socket
before working on the appliance.
♦ Remove the pivoting guard
♦ Turn the quick-release chuck
this position.
♦ Press the required saw blade into the quick-
release chuck as far as the limit stop.
♦ Release the quick-release chuck
return to its initial position. The saw blade is
now locked.
■ WARNING! The saw blade teeth must point
forwards at this point (see foldout page)!
♦ Replace the pivoting guard
device.

Fitting the guide fence

The guide fence can be fixed on the left or right
of the appliance.
♦ Undo both the clamping screws on the insertion
openings .
♦ Push the guide fence
ings .
♦ Retighten the two clamping screws.
Connecting the sawdust extraction
appliance
♦ Push the reducer
until it is secured.
♦ Attach an approved dust and sawdust extractor
to the reducer or extraction connector
directly.
│ GB │ IE │ NI │ CY
■ 6
.
and hold it in
– it must
back onto the
into the insertion open-
into the extraction connector

Fitting the splinter guard

The splinter guard can prevent the tearing up of
the surface when sawing wood. The splinter guard
can only be used with certain sawblade types
and only at a cutting angle of 0°.
♦ Press the splinter guard
from below (arrow facing upwards).

Operation

Setting the cutting angle

♦ Push the clamping lever
baseplate to the front.
♦ Adjust the cutting angle to 0°/ 22,5°/ 45° with
the aid of the markings on the baseplate
Push the baseplate
locking pin engages in the toothing
♦ Push the clamping lever
NOTE
► With a cutting angle of 22,5°/ 45°, the pivoting
guard must be removed beforehand! If the
baseplate cannot be locked well by clamping
lever , remove the extraction connector
then tighten the clamping screw

Setting the stroke rate

♦ Use the stroke rate preselection adjusting
wheel to set the required stroke rate.
into the sliding shoe
forward and pull the
.
to the rear so that the
.
backwards.
,
with hex key.
PSTK 800 B2