Setting The Pendulum Stroke; Switching On/Off; Switching The Laser/Working Light On/Off; Sawdust Blowing Function - Parkside PSTK 800 B2 Originalbetriebsanleitung

Setting the pendulum stroke

♦ You can use the pendulum stroke switch
the pendulum movement of the saw blade
You can achieve fine, clean cut edges without
pendulum movement (setting "0"). Switch the
pendulum movement off when working on thin
workpieces. You can achieve an increasingly
fast workrate with activated pendulum stroke
(settings 1–3).
Switching on/off
Switching the appliance on:
Slide the ON/OFF switch
Switching the appliance off:
Slide the ON/OFF switch
position "0".
Switching the laser/working light
on/off
On/off switch:
Press the ON/OFF switch
function is active.
LASER and WORKING LIGHT → WORKING
LIGHT → LASER → SWITCH OFF

Sawdust blowing function

Switching the sawdust blowing function on:
♦ Slide the sawdust blower function switch
the position .
Supporting the extraction function:
♦ Slide the sawdust blower function switch
the position "0".
PSTK 800 B2
to set
.
forward to the position "I".
backward to the
until the required
in
in

Maintenance and Cleaning

WARNING! RISK OF INJURY!
Switch the appliance off and remove
the power plug before starting any
work.
■ The appliance must always be clean, dry and
free from oil or grease.
■ To clean the casing, use a soft dry cloth.
WARNING!
■ To avoid potential risks, damaged mains
cables should be replaced by the manufac-
turer, their customer service department or a
similarly qualified person.
■ Replace the saw blade
are blunt and proper sawing is therefore no
longer possible.
■ Clean the appliance after completing your
sawing work.
■ Remove any dirt (e.g. sawdust). If necessary,
clean the saw blade mounting with a brush or
blow it out with compressed air.
as soon as its teeth
GB │ IE │ NI │ CY │ 7 ■