Initial Operation; Fitting/Changing The Saw Blade; Fitting The Guide Fence; Connecting The Sawdust Extraction Appliance - Parkside PSTK 800 A1 Originalbetriebsanleitung

Initial operation

GB

Fitting/changing the saw blade

Always remove the plug from the power socket
before working on the appliance.
♦ Remove the pivoting guard
♦ Turn the quick-release chuck
this position.
♦ Press the required saw blade into the quick-
release chuck
♦ Release the quick-release chuck
return to its initial position. The saw blade is
now locked.
■ WARNING! The saw blade teeth must point
forwards at this point (see foldout page)!
♦ Replace the pivoting guard
device.

Fitting the guide fence

The guide fence
of the appliance.
♦ Undo both the clamping screws on the insertion
openings .
♦ Push the guide fence
ings .
♦ Retighten the two clamping screws.
Connecting the sawdust extraction
appliance
♦ Push the reducer
until it is secured.
♦ Attach an approved dust and sawdust extractor
to the reducer
directly.

Fitting the sliding shoe

When working on sensitive surfaces, you can fit
the sliding shoe
scratching the surface.
6
.
and hold it in
as far as the limit stop.
– it must
back onto the
can be fixed on the left or right
into the insertion open-
into the extraction connector
or extraction connector
on the baseplate to avoid
♦ Mount the sliding shoe
and press it up at the back until it clicks into
place on the baseplate
♦ To remove the sliding shoe
the rear of the baseplate
forwards.

Operation

Setting the cutting angle

♦ Push the clamping lever
baseplate to the rear.
♦ Adjust the cutting angle to 0°/15°/30°/45°
with the aid of the markings on the baseplate
Push the baseplate
locking pin engages in the toothing
♦ Push the clamping lever
NOTE
► With a cutting angle of 30 ° / 45 °, the pivoting
guard must be removed beforehand! If the
baseplate cannot be locked well by clamping
lever , remove the extraction connector
then tighten the clamping screw

Setting the stroke rate

♦ Use the stroke rate preselection adjusting
wheel to set the required stroke rate.

Setting the pendulum stroke

♦ You can use the pendulum stroke switch
the pendulum movement of the saw blade
You can achieve fine, clean cut edges without
pendulum movement (setting "0"). Switch the
pendulum movement off when working on thin
workpieces. You can achieve an increasingly
fast workrate with activated pendulum stroke
(settings 1–3).
Switching on/off
Switching the appliance on:
Slide the ON/OFF switch
Switching the appliance off:
Slide the ON/OFF switch
position "0".
onto the baseplate
.
, unfasten it at
and slide it off
forward and pull the
to the front so that the
.
backwards.
,
with hex key.
to set
.
forward to the position "I".
backward to the
PSTK 800 A1
.