Preparing Waffles - Unold WAFFELAUTOMAT FLIP 48205 Bedienungsanleitung

4. The green indicator light will be
illuminated as soon as the pre-
heating phase ends.
5. After pre-heating the appliance
there may already be visible tra-
ces of use; however, these do
not affect the function of the
appliance and do not constitute
grounds for a complaint.
6. Before using the waffle maker for
the first time, lightly grease both
baking surfaces with a brush with
a heat-resistant shortening, e. g.

PREPARING WAFFLES

Opening and closing the appliance: The appliance should only be opened or closed
when the top side with the two indicator lights is pointing up.
1. Connect the appliance, plug the
mains plug into an electrical out-
let (230 V~, 50/60 Hz). The ope-
rating indicator light is illumina-
ted and shows that the heating
circuit is in operation.
2. Wait until the green indicator light
is illuminated. Open the appli-
ance.
3. Now pour the batter onto the
middle of the lower baking surface
with a ladle. When closing the
appliance the batter is distributed
uniformly. Always ensure that you
correctly dose the amount of bat-
ter. If you use too little batter the
upper part of the appliance will
not sit correctly; in this case the
waffles will not be as brown on top
as they are on the bottom. If you
use too much batter the excess
batter will overflow and adhere on
the appliance and the countertop.
20
Copyright UNOLD AG | www.unold.de
margarine. Because the baking
surfaces of the appliance have a
non-stick coating, they must only
be greased prior to making the
first waffle, thereafter greasing is
no longer required.
7. If a mild odour becomes percep-
tible after heating up your new
appliance for the first time, it is
completely harmless.
8. The first waffle that you make is
not suitable for consumption and
must be disposed of.
4. After pouring on the batter, close
the appliance immediately so that
the waffle browns uniformly on the
top and bottom.
5. Ensure that the closure clip is pro-
perly engaged.
6. After 3 to 4 min., turn the appli-
ance 180°, so that now bottom
side is pointing up.
7. Wait approx. 3 to 5 minutes and
turn the appliance back to its ini-
tial position so that the indicator
lights point up.
8. Carefully open the appliance and
remove the finished waffle. Do
not use any metallic objects to do
this, to avoid scratching the coa-
ting of the baking plates.
9. If the waffle is not yet brown
enough, close the appliance and
repeat steps 5 and 6 until the
waffle is the way you like it.