First Use; Preparing The Waffles - Unold 8425 Bedienungsanleitung

18. The appliance becomes hot during operation.
Please use the handles or pot holders when
moving the appliance.
19. Do not leave the appliance unattended when
it is still hot. Risk of burns!
20. Open the lid completely when placing the
dough onto the waffle plates or removing
the waffles. Otherwise the lid may fall down.
Risk of burns and injury!
21. For safety reasons never cover the appliance
or the waffle plates with paper, plastic film
or other foreign material. Otherwise the risk
of fire hazard exists!
22. Never touch the waffle plates during
operation or shortly afterwards with any part
of the body or heat sensitive objects.
23. Do not store the appliance when it is still
hot.
the manufacturer does not assume any warranty in case of improper or incorrect use or after repair by
unauthorized third parties.

firSt uSe

1. Before first use, we recommend cleaning the
non-stick waffle plates with a damp cloth.
2. Close the appliance and connect the plug
to a wall socket (230 V~, 50 Hz). The red
control lamp lights up and indicates that the
heating is operational.
3. Turn the temperature control to the interme-
diate position to start to preheat. When the
appliance has reached the preset tempera-
ture, the green control lamp lights up.
4. Heat the appliance up for a couple of
minutes without dough, in order to eliminate
possible manufacturing residues. Make
sure the room is well ventilated during this

PreParing the WaffleS

1. Place the dough in the middle of the lower
waffle plate using a ladle. The dough will
be spread evenly over the waffle plates by
closing the lid of the appliance. Please make
sure you use the right quantity of dough. If
the quantity of dough is insufficient, the
upper part of the appliance does not close
properly and the upper side of the waffles
will not be as brown as the lower side. If it is
too much, the dough will overflow and soil
the appliance and the worktop.
2. Close the appliance immediately after
placing the dough, so that the waffle will
brown evenly on both sides.
24. Check the plug and lead cable regularly for
wear and damage. In case the lead cable
or other parts present damages, please
send the appliance to our after-sales service
for inspection and repair (for address, see
warranty terms). Unauthorised repairs can
constitute serious risks for the user and void
the warranty.
25. If the lead cable is damaged, it must be
replaced by the manufacturer or its after-
sales service or a similarly qualified person
in order to avoid any hazard.
caUtIoN:
the appliance becomes very hot during
operation!
process. After the initial heating process
the appliance might show signs of wear,
which do not affect its features and do not
constitute a reason for rejection.
5. Before first use, slightly grease both waffle
plates with heat resistant grease like
margarine, for example, using a pastry brush
(as the waffle plates are non-stick coated,
greasing is only necessary before the very
first use).
6. The appliance may generate a slight smell
when first using it, which is absolutely nor-
mal.
3. A few seconds after placing the dough, the
green control lamp turns off. The appliance
will be heated up again and the baking
process starts.
4. The temperature control is continuously
adjustable: with a lower level adjustment,
the waffles will be light brown and dark
brown with a higher level adjustment. Any
other browning grade desired is continuously
adjustable between highest and lowest
adjustment.
5. When the baking process is finished, the
green control lamp lights up again. This
indicates that the waffles are ready and can
13