Metz MECABLITZ 50 AF-1 digital Sony Bedienungsanleitung Seite 86

Tip:
If you do not necessarily need the full guide number and maximum flash range
of the flash unit, you can leave the zoom reflector at the position for the shortest
focal length of the zoom lens. This will provide full light coverage of the picture
and eliminate the need to continually adjust it to the focal length of the lens.
Example:
You use a zoom lens with a focal length range of 35 mm to 105 mm. In this
case, you set the position of the main reflector of the flash unit to 35 mm.
Resetting to auto-zoom
• Touch the shutter release to begin a data transfer between the flash unit and
the camera.
• Press the button combination „Select" until
„M.Zoom" appears flashing next to the
zoom position (mm).
• Press the button + until the 105 mm position has
been exceeded. The flashing display „M.Zoom"
changes to „Zoom" (= auto-zoom mode) and the
TTL
Zoom
14 35
m mm
Zoom
The return from manual zoom mode to auto-zoom mode also occurs if
the flash unit is switched on again with the main switch
86
zoom position of the main reflector
automatically adjusted to the lens focal
length.
The setting takes effect immediately.
After about 5 seconds the display stops flas-
hing and the setting is saved automatically.
.
Wide-angle diffuser
With the wide angle diffuser
illuminated (35 mm format).
Pull the wide-angle diffuser
reflector as far as it will go, and then release it. The
wide-angle diffuser automatically folds down-
wards. The main reflector
the required position. The distance readings and the
zoom value are corrected to 12 mm on the display
panel.
The automatic adjustment of the motor-zoom main reflector
activated if the wide-angle diffuser is in use.
To insert the wide-angle diffuser
way in.
Mecabounce 58-90
If the Mecabounce 58-90 (optional accessories, see 17) is fitted to the main
reflector of the flash unit, the main reflector is automatically guided to the
is
position required. The distance data and zoom factor are corrected to 16 mm.
The automatic adjustment of the motor-zoom main reflector
activated if the Mecabounce is in use.
The simultaneous use of the wide-angle diffuser and the Mecabounce is
not possible.
, focal lengths of 12 mm or more can be
out from the main
automatically moves to
, turn it upwards 90° and push it all the
is not
is not