Manual Flash Mode - Metz MECABLITZ 50 AF-1 digital Sony Bedienungsanleitung

TTL flash mode
This analogue flash mode is supported by older analogue cameras.
It is the normal TTL flash mode (TTL flash mode without preflash).
Setting procedure
TTL
TTL
20 35
m mm
Zoom
Automatic fill-in flash operation in the TTL operating modes
The automatic fill-in flash mode is activated by most cameras when the automa-
tic programme P is selected and by Vari or subject programmes during daylight
(see camera operating manual).
Fill-in flash mode overcomes troublesome shadows and produces a more balan-
ced exposure between subject and background with contre-jour shots. The
camera's computer-controlled metering system sets the most suitable combina-
tion of shutter speed, aperture and flash output.
Ensure that the contre-jour light source does not shine directly into the
lens, as this will interfere with the camera's TTL metering system!
There is no setting or display for automatic fill-in flash in the flash unit.
TTL
• Press „Mode" until „ " flashes in the
display.
The setting takes effect immediately.
After about 5 seconds the display stops flas-
hing and the setting is saved automatically.
TTL
„ " appears in the display.

7.2 Manual flash mode

M
In the manual flash mode „ " , the flash unit emits the full uncontrolled
amount of light if no partial light output has been selected. The specific photo-
graphic situation can be taken into account by adjusting the aperture setting or
by selecting a suitable manual partial light setting. The setting area ranges from
P 1/1 to P 1/128 in M mode and P1/1 - P1/32 in HSS mode (see 7.3).
The display shows the distance at which the subject is correctly lit (see 5.2).
Setting procedure
M
• Press „Mode" until „ " flashes
in the display.
The setting takes effect immediately.
After about 5 seconds the display stops flashing and
the setting is saved automatically. „
the display.
Manual partial light output levels
M
In manual flash mode set the partial
light output desired with the buttons
+ and –. The setting takes effect immediately
and is saved automatically.
The distance display is adjusted to the partial light
output automatically (see 5.2).
Various camera models support the manual flash mode
camera mode manual M! In other camera models an error message
appears in the display and the release is locked!
M
M
17
m
Zoom
M
" appears in
M M
P 1/4
8,6
m
Zoom
P1/4
M
only in the
35
mm
35
mm
83