Assembly; Npacking; Clean U P; Site Considerations - Holzmann UWS 320 Bedienungsanleitung

13 ASSEMBLY

13.1 Unpacking
The Universal Tool Grinding is shipped from the manufacturer in a carefully packed carton. If you
discover the machine is damaged after you've signed for delivery, immediately call Customer
Service for advice.
When you are completely satisfied with the condition of your shipment, you should inventory its
parts.
When the wooden case is hung up, pay attention that the case is firm or not. The case should not
be shaken and struck when lifting up and down.
When installing the machine, the body and the base must be level, without swinging.
The wire can be connected when the machine is installed. Insert the plug in the socket of the
main power. Connect the wire to the ground, turn on the switch to start the grinding head motor
and headstock motor, observe if the sand wheel and headstock turns in a right way.
13.2 Clean Up
The unpainted surfaces are coated with a waxy oil to protect them from corrosion during ship-
ment. Remove this protective coating with a solvent cleaner or citrus-based degreaser. Avoid
chlorine-based solvents as they may damage painted surfaces should they come in contact. Al-
ways follow the usage instructions on the product you choose for clean up.
13.3

Site Considerations

FLOOR LOAD
Your Universal Tool Grinding represents a heavy-duty weight load in a small footprint. Most com-
mercial or home shop floors should be sufficient to carry the weight of the Universal Tool Grind-
ing. If you question the strength of your floor, you can opt to reinforce it. Ensure that the stand
you use with the Universal Tool Grinding is capable of supporting the machine.
WORKING CLEARANCES
Working clearances can be thought of as the distances between machines and obstacles that al-
low safe operation of every machine without limitation. Consider existing and anticipated machine
needs, size of material to be processed through each machine, and space for auxiliary stands
and/or work tables. Also consider the relative position of each machine to one another for effi-
cient material handling. Be sure to allow yourself sufficient room to safely run your machines in
any foreseeable operation.
LIGHTING AND OUTLETS
Lighting should be bright enough to eliminate shadow and prevent eye strain. Electrical circuits
should be dedicated or large enough to handle combined motor amp loads. Outlets should be lo-
cated near each machine so power or extension cords are not obstructing high-traffic areas. Be
sure to observe local electrical codes for proper installation of new lighting, outlets, or circuits.
.
HOLZMANN Maschinen Austria ξ www.holzmann-maschinen.at
Universal Werkzeugschärfmaschine / universal tool grinding machine
ASSEMBLY
Seite 29
UWS 320