Adjustments; Travel Of The Grinding Head; Working Table; Lide - Holzmann UWS 320 Bedienungsanleitung

14 ADJUSTMENTS

14.1

Travel of the Grinding Head

The grinding head is fixed on the pillar. The head wheel on the upper pillar can move it. When the
hand wheel is turned one circle, the head moves 2 mm. When the hand wheel is turned one division,
the head moves 0.02mm accurately.
The sand wheel axle is connected with the motor shaft. The angle of the sand wheel axle can be ad-
justed by the fasten lever (7).
The grinding head can be adjusted by loosening the two bolts. The safety cover can be revolved 360º
by the fasten screw (10) on the top of the cover.
14.2

Working Table

There is a 14mm wide T-type groove on the working table, on which every kind of accessory can be
fixed in a suitable position. It¹s movement can be conducted by the hand wheel (14).
The travel of the working table can be located by the positioning block(5) on the pillar side. The ad-
justing bolt (4) can be used to fine adjust the table. The hand wheel (14) can be used to let table
move again.
14.3 Slide
The slide can be moved 150mm forward and backward. When the hand wheel (6) is turned one circle,
the slide moves 3mm. One division on the scale shows 0.03mm movement.
HOLZMANN Maschinen Austria ξ www.holzmann-maschinen.at
Universal Werkzeugschärfmaschine / universal tool grinding machine
ADJUSTMENTS
Seite 30
UWS 320