Holzmann UWS 320 Bedienungsanleitung Seite 27

18. SECURE WORK. Use clamps or a vise to hold work when practical. It's safer than using your
hand and frees both hands to operate tool.
19. DO NOT OVERREACH. Keep proper footing and balance at all times.
20. MAINTAIN TOOLS WITH CARE.
mance. Follow instructions for lubricating and changing accessories.
21. USE RECOMMENDED ACCESSORIES. Consult the owner's manual for recommended acces-
sories. The use of improper accessories may cause risk of injury.
22. REDUCE THE RISK OF UNINTENTIONAL STARTING. On machines with magnetic contact
starting switches there is a risk of starting if the machine is bumped or jarred. Always discon-
nect from power source before adjusting or servicing. Make sure switch is in OFF position be-
fore reconnecting.
23. MANY WOODWORKING TOOLS CAN "KICKBACK" THE WORKPIECE toward the operator
if not handled properly. Know what conditions can create "kickback" and know how to avoid
them. Read the manual accompanying the machine thoroughly.
24. CHECK DAMAGED PARTS. Before further use of the tool, a guard or other part that is dam-
aged should be carefully checked to determine that it will operate properly and perform its in-
tended function. Check for alignment of moving parts, binding of moving parts, breakage of
parts, mounting, and any other conditions that may affect its operation. A guard or other part
that is damaged should be properly repaired or replaced.
25. NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER OFF. Do not leave tool until
it comes to a complete stop.
26. NEVER OPERATE A MACHINE WHEN TIRED, OR UNDER THE INFLUENCE OF DRUGS
OR ALCOHOL. Full mental alertness is required at all times when running a machine.
27. NEVER ALLOW UNSUPERVISED OR UNTRAINED PERSONNEL TO OPERATE THE MA-
CHINE. Make sure any instructions you give in regards to machine operation are approved,
correct, safe, and clearly understood.
28. IF AT ANY TIME YOU ARE EXPERIENCING DIFFICULTIES performing the intended opera-
tion, stop using the machine! Then contact our service department or ask a qualified expert
how the operation should be performed.
29. The supply voltage should not exceed 10℅of the specified voltage of the machine otherwise
the electrical parts will be worn out.
30. The safety guards on the sand wheel should be complete and in a good way without being
disassembled or changed casually.
31. Do not touch the feeding hand wheel or electric switch casually. So as to prevent the accident.
32. When the working piece comes close to the sand wheel or the sand wheel is being revised, the
feeding should be smooth and slow enough to keep safe.
HOLZMANN Maschinen Austria ξ www.holzmann-maschinen.at
Universal Werkzeugschärfmaschine / universal tool grinding machine
Keep tools sharp and clean for best and safest perfor-
SAFETY GUIDELINES
Seite 27
UWS 320