Holzmann UWS 320 Bedienungsanleitung Seite 25

•
Do maintenance or adjustment only after switching the machine off and disconnecting the
machine from the power source.
•
Always keep children away from the machine. Operating personal must be at least 18
years old.
•
Do not wear loose clothing, gloves, neckties or jewelry (rings, watches, etc). Keep the
sleeves and the edges of the work uniform tight. Always be sure to wear safety goggles
and wear safety shoes during operation.
•
Put the long hair into a safety hat during operation no matter the operator is a man or a
woman.
•
It is recommended to wear suitable hearing protection equipment when necessary to re-
duce the risk of hearing loss.
•
Provide adequate light around the machine, and keep the perimeter around the machine
dry, clean and in good order. In addition, do not place anything near the machine; other-
wise it becomes an obstacle during operation.
•
Do not remove the guards from their working place during operation.
•
Disconnect the power supply before leaving the machine.
•
Restart the machine only after the guards and safety devices are replaced to their position
and in their good function.
•
Do not place tools, work pieces, or other items, which not be in use on the machine, espe-
cially on the moving parts.
•
Clamp workpiece and tools completely and reliably and take off the wrench from chuck be-
fore starting the spindle running.
•
Stop the machine before adjusting the position of the coolant nozzles.
•
Do not use compressed air to remove dust and chips etc. deposited on the machine,
switchboard, control unit etc.
•
Both operators and the maintenance men should read the descriptions carefully on the
caution plate attached on the machine. They should observe the OPERATION MANUAL in
their work. During operation and maintenance, care should be taken so that this caution
plate is not dirtied or damaged.
•
Always bear in mind where the emergency stop button is so that you can operate it with-
out delay in case of an emergency.
•
Start the machine according to the starting procedures strictly.
•
Keep your hands away from the moving parts of the machine during operation.
•
When removing chips caught around the tooling system, avoid taking them out directly by
hand, there is cutting hazards. It is safer with proper tool when doing this. Be sure to stop
the machine when removing chips from the machine.
•
Prior to starting test operation, read this manual carefully so as to be familiar with this
machine.
•
Contact the manufacturer if for some reason the OPERATION MANUAL should become un-
readable.
•
When install a tool, stop the spindle and the feed in each axis.
•
The machine is low-maintenance. It's not necessary to dismount any parts of the machine.
Repairs only by specialists!
•
Accessories: Only use accessories recommended by Holzmann Maschinen.
HOLZMANN Maschinen Austria ξ www.holzmann-maschinen.at
Universal Werkzeugschärfmaschine / universal tool grinding machine
SAFETY GUIDELINES
Seite 25
UWS 320