Step 2 - Recording The Bass - Yamaha MT50 Bedienungsanleitung

10
Chapter 3: Basic Recording
HIGH
+6
+3
– +
0
LOW
-5
-10
– +
AUX
REC
REC
SEL
2
OFF
0 10
R
PAN
CUE
L R
10
10
9
0
8
7
6
GAIN
8
MIC
5
4
3
LINE
2
1
0
2
MIC/LINE
Bass Effect
Processor
YAMAHA
FX550B
MT50 User's Guide
Step 2 — Recording the Bass
1. Connect the bass to MIC/LINE input 2.
Note:
Connecting an instrument with a high output impedance such as an
electric guitar or bass to the MT50 may increase noise and distortion and
9 preclude high quality recordings.
If this happens, connect a direct box or effect unit between the instrument
and the MT50 to reduce the impedance.
2. Set Module 2's GAIN switch to LINE.
3. Set Module 2's CUE slider to about 8.
4. Set Module 2's REC SEL switch to 2.
The REC indicator starts flashing.
4
5. Press the PAUSE button.
6. Press the REC button.
The REC indicator lights up.
7. While strumming the bass, raise Module 2's fader gradually.
You should be able to hear the bass and the level meter should light up.
3
8. Set the fader so that the +6 light is on occasionally at the maximum
input level.
9. In order to set the CUE levels, press the PAUSE button to start
recording. (This is only a temporary recording.)
10. While listening to the drum track, play the bass and set Module 1
2
and 2's CUE sliders so that you can hear the drums and bass clearly.
11. Press REW to rewind the tape to 000.
12. Press the REC button to start recording.
The REC indicator lights up.
13. Play your bass part while listening to the drum track.
14. When your bass part is finished, press STOP to stop recording.
15. Press REW to rewind the tape to 000.
16. Set Module 2's REC SEL switch to OFF.
The REC indicator goes off.
17. Press PLAY to listen to the drum track and new bass track.
If you like the track, go to "Step 3 — Recording the Guitar" once you
finish this procedure. If you don't like it, re-record it.
1
18. Disconnect the bass.
19. Set Module 2's fader to 0.
20. Press REW to rewind the tape to 000.