Faults; Return And Disposal - WIKA CEP 3000 Betriebsanleitung

8. Faults / 9. Return and disposal

8. Faults

Display Type of fault
Low battery power, functioning is only
guaranteed for a short period of time
OL
Reading is significantly above or below
the measuring range
-OL
Batteries are discharged
No display
or undefin-
able characters,
System error
instrument is not
responding to
key press
Instrument faulty
CAUTION!
If faults cannot be eliminated by means of the measures listed above,
the hand-held temperature calibrator must be shut down immediately,
and it must be ensured that signal is no longer present, and it must be
prevented from being inadvertently put back into service.
In this case, contact the manufacturer.
If a return is needed, please follow the instructions given in chapter
9.1 "Return".

9. Return and disposal

WARNING!
Residual media on the dismounted hand-held temperature calibrator
can result in a risk to persons, the environment and equipment. Take
sufficient precautionary measures.
WIKA operating instructions, model CEP3000
Measures
Insert new batteries
Test: Is the measurement parameter
within the approved measuring range
of the instrument?
Insert new batteries
Switch off the instrument, wait for a
short period of time, switch on again
Send in for repair
GB
23