B) Mains Cable/Mains Voltage; C) Location For Installation - VOLTCRAFT V-CHARGE 300 TOUCH Handbuch

• If you are not sure about the correct operation or if questions arise which are not
covered by the operating instructions, please do not hesitate to contact us or
another specialist.

b) Mains cable/mains voltage

• Product setup corresponds to protection class I. Only a proper protective-contact
mains socket must be used for connection of the charger via the mains cable.
• The mains socket to which the plug-in mains unit is connected must be easily
accessible.
• Do not pull the mains plug from the mains socket by pulling the cable.
• If the mains unit or charger are damaged, do not touch it. Danger to life from
electric shock!
First switch off the mains voltage for the mains socket to which the mains cable is
connected (switch off the corresponding circuit breaker or take out the fuse, then
switch off the fault interrupter protection switch (FI circuit breaker) so that the
mains socket is separated from the mains voltage on all poles).
Only then unplug the mains unit from the mains socket.
If the charger is damaged, stop operating it. Take it to a specialised workshop or
dispose of it in an environmentally friendly way.
If the mains cable is damaged, dispose of the damaged mains cable in an envi-
ronmentally compatible way. Do not use it anymore. Replace it with a new mains
cable of the same specifications.

c) Location for installation

• The charger is intended for dry indoor use only. It must not become damp or wet.
If the charger is operated via the mains cable, there is danger to life from electric
shock in case of moisture/wetness on the charger/mains cable!
• Avoid direct sun irradiation, strong heat or cold. Keep the charger away from dust
and dirt. The same applies to any rechargeable battery that may be connected.
60