Conrad Electronic RM100B868P1 Bedienungsanleitung Seite 41

• Fasten the module covering with the two screws.
• The house code of the smoke alarm can be set using the jumpers J1 to J4.
A total of 16 different combinations is possible.
Always make sure that the house code is set the same on all the
smoke alarms. Otherwise the radio smoke alarms will not react
to each other.
• Insert two new Mignon batteries (AA) with the correct polarity into the three
battery brackets. There is a corresponding diagram in the battery
compartments; observe also figure 7.
• After inserting the batteries, the red pilot lamp/LED will flash approx. every
48 seconds and thus signalises that the smoke alarm is ready for operation.
-
+
-
+
+
-
Figure 6
Figure 7
41