B) Connecting And Installing The Receiver Batteries - Reely DLG 650 RC Bedienungsanleitung

b) Connecting and installing the receiver batteries

Before the receiver battery (1) can be connected to the
model, first turn on the transmitter.
Only then connect the receiver battery to the reverse po-
larity protected plug connector (2) on the receiver/servo
module in the model.
As soon as the receiver has recognised the digital cod-
ing of the transmitter, a red LED (3) on the receiver/servo
module lights up.
The model is now ready for operation and the servos (4)
should respond to the movements of the joysticks.
Then place the rechargeable battery in the fuselage tip and
push it firmly into the hook-and-loop fastener strap.
The connection cable (5) must be positioned on the side
of the fuselage in a way that does not affect the function
of the servos.
Now place the cabin hood on the fuselage again.
If the LED does not light up, the transmitter may
be not switched on or it may not be recognised
by the receiver.
If the LED blinks slowly, the joystick that is not
held in the centre position by spring tension
must be quickly moved to the bottom position.
Figure 7
41