Starting Of A Programme - Pkm DW12A++7 Bedienungsanleitung

for daily use.
Rapid Short programme
for lightly soiled
dishes without
drying.
Pre-rinse For rinsing dishes
to wash them at a
later point of time.
*EN50242 → this programme is the test-programme.
(Capacity 12 table settings/ upper rack in low position/ rinse aid setting 5 ( 4 when
four setting dispenser)
1. Fill the lower rack first.
2. Pour the dishwasher detergent and the water softener (=dishwasher salt) in the
relevant containers.
3. During operation the appliance must be supplied with water ( full water
pressure).
4. Close the door properly while pressing gently. When the door closes properly
you will hear a light KLICK.
5. Press the PROGRAM button to select a programme.
6. Press the OFF button when the programme has ended. Open the door.
You can only change a programme when it has run a short period of time.
Otherwise the detergent has dissolved and the dishwater has been drained.
In such a case you must refill the detergent container.
1. Press the ON/OFF button to cancel the current programme.
2. Switch on the appliance again.
3. Set the new programme.
4. Close the door.
When you open the door while the appliance is operating, the appliance will stop
operating. The display indicates the code E1. When you close the door again, the
The 6 control lights indicate the status of the appliance.
Drying
Main-wash(40
Hot-rinse
Pre-wash

Starting of a programme

How to change a programme
appliance will start operating after 10 seconds.
0
)
NOTICE!
58
15 g 39-0.50-7
- 11-0.01-4