Pkm DW12A++7 Bedienungsanleitung Seite 59

a) One light is on = the relevant programme is running.
b) One light flashes = Pause - mode.
1. 3in1 detergents contain a combination of detergent, rinse aid and water
softener.
2. Check that the water hardness of your water supply meets the information given
on the packaging of the 3in1 detergent.
3. Strictly observe the instructions of the manufacturer of the 3in1 detergent.
4. If a problem occurs when using a 3in1 product for the first time, contact the
info-hotline of the manufacturer of the 3in1 product.
5. When using a 3in1 product, the indicators for the rinse aid and water softener
are not longer useful. It may be helpful to set the water hardness to the smallest
possible value.
1. Press the ON/OFF button and select the 3in1 programme by pressing the
3in1 button until the 3in1 indicator flashes.
2. The 3in1 programme is available after you pressed the 3in1 button and the
3in1 indicator is on.
1. Follow the instructions in HOW TO CHANGE A PROGRAMME. If you
want to operate the appliance with a standard detergent system again, then
proceed as follows:
a. Fill the water softener and the rinse aid container.
b. Set the water hardness to the highest possible value and let the appliance
operate for 3 normal wash-cycles without load.
You can put dishes later in the appliance unless the detergent container has opened.
1. Open the door slightly to stop operation.
When all lights glimmer = malfunction!
In such a case disconnect the appliance
from the energy and water supply immediately.
How to use 3in1 tabs
How to select the 3in1 programme
How to cancel the 3in1 programme
Later addition of dishes
WARNING!
59