g) Trimming the Helicopter
Push the pitch lever (see figure 1, item 5) carefully forward and observe the response of your model. Shortly before the
helicopter starts hovering, you can already determine in which direction your model wants to move.
If the helicopter fuselage tip tries to turn to the right, reduce the speed and turn the trimming controller for the tail
function (see figure 1, item 4) gradually to the left.
Push the pitch stick carefully forward and check if the adjustment was sufficient. Keep repeating this procedure until
the helicopter no longer has any tendency to turn to the right.
If the tip of the fuselage turns to the left, carry out a right trim adjustment.
Figure 12
36