Cleaning And Storing The Instrument - Beurer M1502 Gebrauchsanweisung

– To view the measurements for user memory , press
the M1 memory button.
– To view the measurements for user memo-
ry , press the M2 memory button.
Your last measurement will appear on the
display.
• Press the relevant memory button (M1 or M2).
If you have selected user memory , the M1 memory
button must be pressed.
If you have selected user memory , the M2 memory
button must be pressed.
A flashes on the display.
The average value of all saved measured
values in this user memory is displayed.
• Press the relevant memory button (M1 or M2).
AM flashes on the display.
The average value of the morning measure-
ments for the last 7 days is displayed (morn-
ing: 5.00 a.m. – 9.00 a.m.).
• Press the relevant memory button (M1 or M2).
PM flashes on the display.
The average value of the evening measure-
ments for the last 7 days is displayed (even-
ing: 6.00 p.m. – 8.00 p.m.).
• When the relevant memory button (M1 or
M2) is pressed again, the last individual
measurement is displayed (in this example,
measurement 03).
• When the relevant memory button (M1 or M2) is
pressed again, you can view your individual measure-
ments.
• To switch the device off again, press the Start/stop
button or wait 30 sec.
You can exit the menu at any time by pressing the
Start/stop button
• To clear the memory of the relevant user memory, you
must first select a user memory.
• Start individual measurement access.
• Press and hold the M1 & M2 memory buttons for
5 seconds.
All the values in the current user memory are
deleted.

8. Cleaning and storing the instrument

• Clean your device and cuff carefully only with a slightly mois-
tened cloth.
• The frequency of cleaning depends on the contamination
level of the device. Clean the blood pressure device and cuff
as soon as any dirt appears on the device.
25
.