Cleaning And Storing The Instrument; Error Messages/Trouble-Shooting - Beurer BM 55 Gebrauchsanweisung

• When the relevant memory button (M1 or
M2) is pressed again, the last individual
measurement is displayed (in this example,
measurement 03).
• When the relevant memory button (M1 or M2) is
pressed again, you can view your individual measure-
ments.
• To switch the device off again, press the Start/stop
button .
You can exit the menu at any time by pressing the
Start/stop button
• To clear the memory of the relevant user memory, you
must first select a user memory.
• Start individual measurement access.
• Press and hold the M1/M2 memory buttons for 5 sec-
onds.
All the values in the current user memory are
deleted.
8. Transferring measurements
Connect the blood pressure monitor to your PC using the USB
cable.
No data transfer may be launched whilst performing a
measurement.
.
PC is shown on the display. Begin the data transfer
PC
in the "HealthManager" PC software. During the
data transfer, an animation is shown on the display.
A successful data transfer is displayed as in
figure 1. If the data transfer is unsuccessful, an
error message appears as in figure 2. In this case,
interrupt the PC connection and start the data
transfer again.
After 30 seconds of not being in use or if commu-
nication with the PC is interrupted, the blood pres-
sure monitor switches itself off automatically.

9. Cleaning and storing the instrument

• Clean your device and cuff carefully only with a slightly mois-
tened cloth.
• Do not use detergents or solvents.
• On no account must you immerse the computer in water,
otherwise liquid can enter it and cause demage.
• When storing the device, make sure that no heavy objects
are placed on top of it. Remove the batteries. The cuff tube
should not have any sharp kinks.

10. Error messages/trouble-shooting

In case of faults, the
Error messages may appear if:
• systolic or diastolic pressure could not be measured (
appears on the display)
• systolic or diastolic pressure was outside the measurement
range ( or Lo Lo appears on the display)
• the cuff is fastened too tightly or loosely (
on the display)
28
_ message appears in the display.
or
figure 1
figure 2
or
appears