PeakTech 1070 Bedienungsanleitung Seite 32

4.3. DC current measurement (DC A)
1. Connect red test lead to "V//mA" jack when the current is less
than 200 mA and to "10 A" jack when the current is larger than
200 mA. Connect the black test lead to "COM" jack.
2. Set the function switch to the desired DC A position.
3. Connect the test leads across the source or load under
measurement.
4.4. Resistance measurement ()
1. Connect red test lead to V//mA jack, black test lead COM jack.
Set the FUNCTION switch to the -position.
2.
3. Connect the test leads across the resistor under measurement.
4. When measuring the resistance, the power should be turned off
and in short circuit statues by connecting the two test leads.
Note:
When you short the test leads in the 200  range, your meter
display a small value (no more than 0.3 ). This value is due to your
meters and test leads internal resistance. Make a note of this value
and subtract it from small resistance measurements for better
accuracy.
-31-