PeakTech 1070 Bedienungsanleitung Seite 31

4.1. Voltage measurement (DC V)
1. Connect red test lead to "V//mA" jack, black test lead to "COM"
jack.
2. Set the FUNCTION switch to the desired V DC position. If not
sure, set to the highest range.
3. Connect the test leads across the source or load under
measurement.
4.2. AC voltage measurement (AC V)
1. Connect red test lead to "V//mA" jack, black test lead to "COM"
jack.
2. Set the FUNCTION switch to the desired AC V position.
3. Connect the test leads across the source or load under
measurement.
-30-