PeakTech 1070 Bedienungsanleitung Seite 22

* The meter is designed to withstand the stated max voltages. If it
is not possible to exclude without that impulses, transients,
disturbance or for other reasons, these voltages are exceeded a
suitable presale (10:1) must be used.
* Replace a defective fuse only with a fuse of the original rating.
Never short-circuit fuse or fuse holding.
* Disconnect test leads or probe from the measuring circuit before
switching modes or functions.
* Do not conduct voltage measurements with the test leads
connected to the mA/A- and COM-terminal of the equipment.
* To avoid electric shock, disconnect power to the unit under test
and discharge all capacitors before taking any resistance
measurements.
* Do not conduct current measurements with the leads connected
to the V/-terminals of the equipment.
* Check test leads and probes for faulty insulation or bare wires
before connection to the equipment.
* Please use only 4mm-safety test leads to ensure immaculate
function.
* To avoid electric shock, do not operate this product in wet or
damp conditions. Conduct measuring works only in dry clothing
and rubber shoes, i. e. on isolating mats.
* Never touch the tips of the test leads or probe.
* Comply with the warning labels and other info on the equipment.
* The measurement instrument is not to be to operated
unattended.
* Always start with the highest measuring range when measuring
unknown values.
* Do not subject the equipment to direct sunlight or extreme
temperatures, humidity or dampness.
-21-