Refill fuel
Danger
Risk of explosion! Only refill diesel oil or
light fuel oil. Unsuitable fuels, e.g. petrol,
are not to be used.
Caution
Never operate device with empty fuel tank
The fuel pump will otherwise be destroyed.
Refill fuel.
Close tank lock.
Wipe off spilled fuel.
Refill detergent
Caution
Risk of injury!
Use Kärcher products only.
–
Under no circumstances fill solvents
–
(petrol, aceton, diluting agent etc.)
Avoid eye and skin contact.
–
Observe safety and handling instruc-
–
tions by the detergent manufacturer.
Kärcher offers an individual cleaning
and care appliances program.
Your dealer will consult you gladly.
Refill detergent.
Install the hand-spray gun, the jet
pipe, the nozzle and the high pres-
sure hose (appliances without hose
drum)
Figure 17
Connect ray tube with hand spray gun
Tighten the screw connection of the
spray lance fingertight.
Insert high pressure nozzle into cover-
ing nut
Install covering nut and tighten firmly
Connect the high pressure host to the
high pressure connection point of the
machine.
Install the hand-spray gun, the jet
pipe, the nozzle, the high pressure
hose and the hose drum (applianc-
es without hose drum)
Figure 17
Connect ray tube with hand spray gun
Tighten the screw connection of the
spray lance fingertight.
Insert high pressure nozzle into cover-
ing nut
Install covering nut and tighten firmly
Figure 4
Install the hose drum with the enclosed
screws, discs and nuts (4 pieces each).
Figure 5
Connect the high pressure hose to the
high pressure connection point of the
hose drum and the appliance.
Connect the high pressure hose of the
hand-spray gun to the hose drum.
Wind the high pressure hose with the
least possible bends (in the clock-wise
direction) on the hose drum.
Caution
Always unwind high pressure hose com-
pletely
Installing spare high pressure hose
Figure 6
Installing the handle
Figure 7
Water connection
For connection values refer to technical
specifications
Connect the supply hose (minimum
length 7.5 m, minimum diameter 3/4") to
the water connection point of the ma-
chine and at the water supply point (for
e.g. a tap).
Note: The supply hose is not included.
– 4
EN
27