Recharging The Batteries - Storch 10,8 V Bedienungsanleitung

WHEN TO CHARGE THE BATTERY PACK
It is not necessary to discharge the battery pack completely before recharging.
The lithium-ion battery can be charged at any time and it doesn't develop a "memory effect" if it is recharged after a
partial discharge.
Remove the battery pack from the tool at an appropriate time.
Refresh the charge level of the battery pack again before prolonged periods of operation.
Due to Lithium-Ion fade-free properties, the only time it is necessary to charge the Lithium-Ion battery pack is when the
pack has reached the end of its charge. To signal the end of charge, power to the tool will drop quickly, or the charge
indicator feature on tools so equipped will indicate diminishing and depleted battery power, Charge the battery pack as
needed.
charge indicator
This tool is equipped with a charge indicator which indicates the battery pack charge level. The green LED on the charge
indicator indicates that the battery is fully charged.
The orange LED on the charge indicator indicates that the battery has used approximately one half of its charge.
The red LED on the charge indicator indicates the battery pack is depleted and needs to be charged.
CHARGING THE BATTERY PACK
NOTE:
This lithium-ion battery pack is delivered partially char-
ged. Charge the battery pack fully prior to first use.
A fully discharged battery pack is fully recharged in 30
minutes at an ambient temperature of between 0°C and
40°C.
Charge the Lithium-Ion battery pack with the correct char-
ger.
Connect the charger to a power supply.
Insert the battery pack into the charger (Fig. 2).
The green light will flash while the battery pack is char-
ging. After charging is complete, the green LED on the
charger will be on. The flickering red light indicates a
defective battery or a bad connection between the battery
and the charger.
The battery pack will fully charge if left on the charger,
but it will not overcharge.
NOTE:
The charger can be operated with the majority of genera-
tors and converters with a rated power of 300 watts or
above.
Original instruction 74