Battery Protection; Cold Weather Operation; Device Description; Battery Operated - Storch 10,8 V Bedienungsanleitung

CORDLESS DELTA SANDER - DELTA
(Fig.1)
1. charge indicator
2. soft grip handle
3. base plate
4. sand paper
5. LED worklight
6. ON switch
7. off switch
8. Vacuum adapter
9. Battery pack
OPERATION OF BATTERY
LOW-BATTERY CAPACITY INDICATOR
If the charge indicator shines red when the switch on, the battery pack power has run out, and the battery pack should
be recharged. Unlike other battery types, lithium-ion batteries provide an even performance throughout their operating
period. The tool will not experience a slow, gradual loss of power as you work. A sudden drop in performance indicates
that the battery pack is depleted and needs to be recharged.
NOTE:
The LED may flash in case of overload or excessive temperature (see below: BATTERY PROTECTION).

BATTERY PROTECTION

The battery protection circuit protects the battery pack from extreme temperatures, over-discharge and overcharge. In
order to protect the battery from damage and to increase its service life, the battery protection circuit switches the bat-
tery pack off as soon as it is overloaded or if it gets too high during use.
This may occur in case of high torque levels, if the sander blocks or is overloaded. The intelligent system switches off
the battery pack when the operating temperature reaches 80°C and returns to normal state as soon as the temperature
has dropped to between 0°C and 40° C.
The LED light flashes slowly when the battery protection circuit detects a transient overload.
NOTE:
A significantly reduced operating capacity after a full charging cycle indicates that the battery pack is depleted and
needs to be replaced.

COLD WEATHER OPERATION

The lithium-ion battery pack provides optimum performance at temperatures between 0° C and 40° C. If the battery
pack is very cold, it may "pulse" during the first minute of operation to warm itself up.
Connect the battery pack to a tool and then operate the tool without exerting a high load. The battery pack will have
warmed up sufficiently after approximately one minute and will start to operate normally.
73 Original instruction