Switching On And Off; Maintenance And Cleaning; Troubleshooting - Parkside PDMFW 15 A1 Originalbetriebsanleitung

NOTE
► Before fitting a new sanding sheet
any dust and dirt from the sanding plate
► Ensure that the dust extraction holes of the
sanding plate and sanding sheet are flush.
Removal:
♦ Simply pull the sanding sheet off the sander
plate .
Switching on and off
Switching on:
♦ First, press the trigger lock
then the trigger
Switching off:
♦ Release the trigger
♦ When you have finished working, disconnect
the tool from the compressed air source.

Maintenance and cleaning

WARNING! RISK OF INJURY! Discon-
nect the tool from the compressed air
supply.
CAUTION!
► Before maintenance, clean off any hazardous
substances that may have accumulated on
the tool (due to working processes). Avoid
all skin contact with these substances. If the
skin comes into contact with hazardous dusts,
this can lead to severe dermatitis. If dust is
produced or swirled up during maintenance,
it can be inhaled.
NOTE
► To ensure correct functioning and a long
service life for the tool, pay attention to the
following points:
■ Sufficient and continuous oil lubrication is highly
important for optimum functioning.
PDMFW 15 A1
, remove
forwards and
to switch the tool on.
.
■ If the tool is exhibiting excessive vibration levels,
the cause of the vibrations must be identified
and repaired.
.
■ Use only the genuine replacement parts recom-
mended by the manufacturer, otherwise you
could put users at risk. In doubt, contact the
Service Centre.
■ Clean the tool with a soft, dry cloth only.
■ Never use sharp or abrasive cleaning agents
under any circumstances.

Troubleshooting

Fault
Speed too
slow, air
escapes from
the outlet.
Tool does
not move;
compressed
air escapes
completely
through the
outlet.
Possible Remedy
cause
Motor parts Check the
jamming due pressure
to dirt. supply filter
for contamina-
tion.
Pressure Check the
supply too pressure
low. supply filter
for contamina-
tion.
Lubricate the
tool as de-
scribed in the
instructions.
If necessary,
repeat the
steps outlined
above.
Motor is Lubricate the
jammed due tool as de-
to material scribed in the
build-up. instructions.
GB │ IE │
25 ■