Hazards Caused By Repetitive Movements; Hazards Caused By Accessories; Hazards In The Workplace - Parkside PDMFW 15 A1 Originalbetriebsanleitung

■ Use personal protective equipment. Always
wear eye protection. Wearing personal pro-
tective equipment such as protective gloves,
non-slip safety shoes or hearing protection,
depending on the type and use of the power
tool reduces the risk of personal injuries and it
is recommended.
■ Wear a safety helmet for overhead work.
■ Do not try to brake the saw blades by applying
lateral counterpressure.
■ Torn or deformed saw blades may not be used.
■ Ensure that the saw blades are fitted properly.
■ Sparks must be diverted safely.
■ Ensure that no hazard is caused by sparks cre-
ated during use. Explosive or flammable dusts
can be generated when processing certain
materials. There is a risk of explosion or fire.
Hazards caused by repetitive move-
ments
■ Users of the compressed air tool may experience
unpleasant sensations in their hands, arms,
shoulders, neck area or other body parts.
■ Assume a comfortable position when working
with the compressed air tool, pay attention to
safe footing and avoid unfavourable positions
or such that make it difficult to keep your bal-
ance. During work over longer periods, the
operator should change posture regularly to
avoid discomfort and fatigue.
■ If the operator notices symptoms such as persis-
tent discomfort, throbbing, pain, tingling, burning
or stiffness, these warning indications should not
be ignored. The operator should consult a quali-
fied medical doctor.
PDMFW 15 A1

Hazards caused by accessories

■ Separate the compressed air tool from the com-
pressed air supply before replacing the attach-
ment or accessory.
■ Only use accessories that are intended for this
appliance and comply with the requirements
and specifications listed in these operating
instructions.
■ Avoid direct contact with the accessory tool
during and after use because it may be hot or
have sharp edges.
Observe the following guidelines:
■ Only use tools that are specifically made for
use with this appliance.
■ Do not use cutting discs or any other cutting
tools (other than the saw blades supplied) with
this appliance.
■ Ensure that the maximum operating speed of
the tool is higher than that of the machine.
■ Self-adhesive grinding discs must be applied
concentrically on the mounting plate.

Hazards in the workplace

■ Slipping, tripping up and falling are the main
causes of injuries in the workplace. Watch out
for surfaces that may have become slippery
from the use of the compressed air tool and
tripping hazards caused by the air hose.
■ Proceed with caution in new surroundings.
Hidden hazards caused by power or other
supply lines may be present.
■ This compressed air tool is not suitable for use
in explosive atmospheres and is not insulated
against contact with power sources.
■ Make sure (e.g. by using a metal detector) that
there are no hidden power, water or gas lines
in the location where you are working.
GB │ IE │
19 ■