Kärcher STH 8.66 W Bedienungsanleitung Seite 17

Replacing shearing bolts
Figure 5
The snails (3) are fastened to the drive
shaft (4) using shearing bolts (1) and safety
splints (2). The bolts are designed in such
a way that they break (shear off) when the
snail comes in contact with foreign bodies.
This protects the machine against damag-
es. These parts should only be replaced by
original spare parts (Spare bolts and safety
splints are included in standard delivery).
Remove broken bolts (1) and safety
splint (2); clean and lubricate the fas-
tening point.
Use new shearing bolts and new safety
splint.
Figure 8
Note: The replacement bolts and safety
splints can be fastened to the dashboard.
Replacing the clearing plate
Figure 4
Remove screws (5) and nuts (6).
Replace the clearing plate (4).
Fasten new clearing plate to the casing
using screws and nuts.
Replacing the landing skids
Figure 4
Remove nuts (2) and screws (3).
Loosen the landing skids (1) on both the
sides of the casing.
Adjust the new landing skids (see "Ad-
justing the landing skids").
Reset the chute adjustment bar.
Figure 9
If necessary, if the chute can no longer be
rotated completely, the chute adjustment
bar can be adjusted.
Remove splint.
Pull the adjustment bar back a bit and
install it into the second installation hole
by means of the spint.
Troubleshooting
Danger
Risk of injury!
Before doing any work on the machine:
– Switch off engine.
– Wait till all the moving parts have come
to a stand-still.
– Pull out the ignition key and the ignition
plug.
– Allow engine to cool down.
Note:Some of the functioning problems
have simple causes and you can rectify
them easily. Call up an authorised work-
shop in case of doubt or if mentioned ex-
plicitly.
Note: Repairs should only be done by au-
thorised workshops using original spare
parts.
6
-
EN 17