Connecting The Wireless Camera; Connecting The Wireless Receiver To A Monitor - Conrad 75 16 16 Bedienungsanleitung

6.2 Connecting the wireless camera

• Connect the low voltage plug of the supplied wall power supply with the "DC IN
V/DC 1A" (8) power socket on your wireless camera.
• Plug the wall power supply into a suitable mains socket.
• The POWER LED (3) lights up red permanently to indicate that the device is
properly powered.

6.3 Connecting the wireless receiver to a monitor

• Plug the 3.5mm jack plug of the provided audio/video cable (= 3.5 mm jack to 2 x
RCA adapter cable) into the "A/V OUT" (13) socket.
• Connect the white RCA plug of the adapter cable with the audio input of your dis-
play device.
• Connect the yellow RCA plug of the adapter cable with the video input of your
display device.
• Screw the aerial onto the receiver.
• Connect the low voltage plug of the supplied wall power supply with the "DC IN 5
V/DC 1A" (14) power socket on your wireless receiver.
• Plug the wall power supply into a suitable mains socket.
• The POWER LED (22) lights up red permanently to indicate that the device is
properly powered.
To avoid distortions or mismatches that could damage the devi-
ce, the audio connector (white) may only be connected to an
RCA audio output.
The video connector (yellow) may only be connected to an RCA
video input.
If you are not sure about the correct connection, contact our
technical support or another specialist.
54