Inhaltsverzeichnis
Werbung
English
1.
Switching on – electric
“Before switching on the machine, ensure the following:
!
The mains switch is on.
The water mains tap is open”.
Press the master switch (1); the indicator light “machine on” (2) switches
on.
At the same time, the current working pressure “boiler pressure 0.00
bar” is displayed (14).
If the water level in the boiler is less than the minimum required, the
indicator light “boiler level” (4) lights up and the boiler is filled up to the
correct level (indicator light 4 switches off).
Press the master switch (1a) to position 2.
The heating element inserted indicator light (3) lights up.
The boiler is heating. Wait until the pressure reading on the display
corresponds to the required working pressure value, i.e. the indicator
light (3) switches off.
2.
Cup-Warmer (where contemplated)
CHARACTERISTICS
- Roomy cup-heating shelf
- Choice of several heating temperatures
Arrange the cups on the shelf. Best results are obtained when NOT
MORE than three layers of cups are put on the shelf.
To change the cup-warmer power, press the key (6) a number of times.
- All LEDS on = full power
- All LEDS off = OFF
When the machine is turned off after the day’s operations, the selections
will remain in the machine’s memory.
3.
Initial rinse
!
!
Before operating the machine, perform a rinse of the internal
circuits and change the water in the boiler.”
3.1 Changing the water in the internal groups circuits
Remove the filter carriers (21, 25) of the distributor groups.
Via the continuous distribution key (30), empty the water from each
group for approximately one minute. Repeat this operation twice.
3.2 Changing the water in the boiler
Ensure that the indication on the display corresponds to the working
pressure value.
Keep the hot water distributor key (13a) pressed down for approximately
5 seconds.
The following message will be displayed: “water change”, followed by
an audio signal. The water from the boiler will drain from the hot water
nozzle (10).
All the other keys will be deactivated.
When only steam is issued from the nozzle (10), press the hot water
distributor key (13a) again.
The machine will return to its normal functions and the boiler will be
refilled with water.
1
1a
2
3
30
10
13a
English
4
6
Werbung
Inhaltsverzeichnis
