Inhaltsverzeichnis
Werbung
English
1.
How to access programming
" The Programming operations can only be performed if the
!
function USER PROGRAMMING is activated”.
To access programming, keep the PROG (32) key pressed down until
an audio signal is issued from the machine and the following message
is displayed:
user dose setup
press a key
2.
User dose
user dose setup
press a key
2.1
User dose - programming the cappuccino distribution keys
PROGRAMMING THE CAPPUCCINO DISTRIBUTIN KEYS
(26, 27, 28 and 29 of the group on the left as seen by the operator)
N.B.: Valid only if the CAPPUCCINO function is activated.
When one of the cappuccino distribution keys is pressed (shown by
the flashing led), the following message will be displayed:
key 03
coffee dose
To perform the coffee dose programming, follow the procedure
herebelow:
1) Fill the filter carrier (21) with the correct dose of ground coffee) and
insert into the group ensuring it is correctly locked in place (do not
use previously used coffee grounds).
2) Place the cup by the filter carrier spout (21).
3) Keep the distributor key pressed, as evidenced by the flashing led
(the coffee dose counter starts from zero and increases in value).
4) When the quantity of the coffee in the cup has reached the desired
level, release the key (the counter will indicate the number of pulses
that correspond to the set dose).
It is also possible to vary the coffee doses or set the dose using the “+”
(34) and “-” keys (35).
N.B.: If the coffee dose is set to “000”, the key may only be used for
milk distribution.
When the key
(33) is pressed, the following message is displayed
4 4 4
key 03
milk
To memorize the programming of the milk dose, follow the procedure
herebelow:
4
200
4
10.0
During the programming phase, the audio signal will be repeated every
10 seconds.
To return to the programming phase, keep the PROG (32) key pressed
down until the following message is displayed:
Monday
Boiler pres.
When one of the dose distribution keys are pressed (cappuccino, coffee,
milk or hot water), its value can be programmed.
1) Place the cup (containing a previously programmed dose of coffee)
by the cappuccino maker (18).
2) Keep the distributor key pressed, as evidenced by the flashing led
(the coffee dose counter starts from zero and increases in value).
3) When the quantity of milk in the cup has reached the desired level,
release the key (the counter will indicate the rime that correspond to
the set dose).
It is also possible to vary the milk dose or set the dose using the “+”
(34) and “-” keys (35).
N.B.: If the coffee dose is set to “00.0”, the key may only be used for
coffee distribution.
When the key
(33) is pressed, the following message is displayed
4 4 4
key 03
milk start
The “start milk” time can be increased or decreased using the “+” (34)
and “-” (35) keys.
When the “00” value is set, first milk and then coffee will be distributed
into the cup.
When the “01” value is set, the distribution of milk and coffee will be
simultaneous.
When any of the other values (max. 60) are set, the coffee will be
distributed first, and after a set period of time the milk will be distributed.
N.B.: When high values are set (above the coffee distribution times),
the milk distribution will start upon completion of the coffee distribution.
How to perform other operations
The programming of another key is made by pressing one of the other
distribution keys.
When the key
(33) is pressed, the message “user dose” (Paragraph
4 4 4
2) will be displayed.
When the FRAME DISPLAY (31) key is pressed, the message “clock
program” is displayed (See Paragraph 3).
English
11:00
1,20 bar
4
10
Werbung
Inhaltsverzeichnis
