Updating The Firmware Automatically - Yamaha PJP-100H Bedienungsanleitung

Updating the firmware automatically

Follow the procedure below to install the latest firmware
automatically.
Notes
• Automatic firmware update can be performed only if this unit is
connected to the Internet. If connection is not possible, follow
the procedure in "Updating the firmware manually" (page 46).
• Once the firmware update is started, do not perform any other
operation until the update operation is completed and this unit is
restarted. If the update operation is interrupted, this unit may
become unusable, in which case you need to return this unit to
the factory for repairs.
• When the firmware update is completed, this unit is restarted
automatically. All of the calls being connected are disconnected
at this time.
• Do not unplug the LAN cable during the firmware update.
Otherwise, this unit could become in which you need to return
this unit to the factory for repairs.
y
You can also specify the URL from which the firmware is
downloaded (page 46)
1
Press in the initial display.
The menu display appears.
2
Press or to select "1. Settings", and
then press .
The "Settings" menu appears.
Settings
1. Network Settings
2. Sound Settings
3. General Settings
1 2 3
4 5 6
7 8 9
0
MIC MUTE VOL
3
Press , and then press
"6. Firmware Update".
Settings
4. Save/Load Config
5. Restore Settings
6. Firmware Update
4
Press .
The "Firmware Update" menu appears.
Firmware Update
ver. DT1.12-V1.6x
1. Yes
2. No
5
Press or to select "1. Yes", and then
press .
This unit connects to the Internet and downloads the
latest firmware. When downloading is completed, the
firmware update is automatically started.
The firmware update process takes a few
minutes to complete.
MIC MUTE (red LED) on the top panel of this unit
flashes during the firmware update process. Do not turn
this unit off while MIC MUTE (red LED) is flashing.
■ When the firmware update is complete
This unit restarts automatically.
Check the version number in the "Program Version" on
the top of the Web menu to confirm that the new firmware
has been installed properly.
Updating the Firmware
or to select
45