Display And Speaker Output During Multiple Connections - Yamaha PJP-100H Bedienungsanleitung

Talking with Multiple Locations
Display and speaker output during
multiple connections
The information display and speaker output method vary
depending on the settings in "Connection Mode"
(page 27) and "Speaker Mode" (page 29).
■ When the "Speaker Mode" is
set to "Divide"
IP address of this unit
192.168.0.10
192.168.100.20
192.168.100.30
192.168.100.40
Menu :Address
IP address of other units
The audio from each location is output from a different
position.
, and displayed before the IP address of
each location indicate the positions of the speakers where
the audio from respective locations are output.
Positions in 4-location call
1 2 3
4 5 6
7 8 9
0
MUTE VOL
y
• Also you can change the speaker output positions according to
locations, when the connection mode (page 27) is set to "Mesh"
and the speaker mode is set to "Divide". See "Changing the
speaker output positions according to locations" (page 23).
• Each time you press , you can switch between IP address
and setting icon shown at the top of the display. (When using an
SIP server, the display switches between SIP address, setting
icon, and IP address.)
22
Positions in 3-location call
1 2 3
4 5 6
7 8 9
0
MUTE VOL
■ When "Speaker Mode" is other than
"Divide"
IP address of this unit
192.168.0.10
[1] 192.168.100.20
[2] 192.168.100.30
[3] 192.168.100.40
Menu :Address
IP address of other units
The audio from other locations is not divided according to
locations, but are mixed and output as monaural audio.
The order of connections is displayed before the IP
addresses of other units.
y
See page 38 for the display during a call through the SIP server,
and see page 43 for the display in cascade connection.