Adjusting The Volume - Yamaha PJP-100H Bedienungsanleitung

y
• Press to pick up audio from all directions.
5
• You can select multiple areas at the same time.
• You can select areas where the audio pickup feature is not
applied.
Using the keys on this unit
In the initial display, select "Menu" → "Settings" →
"Sound Settings" → "Microphone Mode".
y
You can display the "Microphone Mode" menu by holding down
in the initial display or calling display.
Using the Web menu
In the Web menu, select the "Microphone Mode".

■ Adjusting the volume

The audio input volume from the microphones and the
audio input/output volumes from/at the AUDIO IN/OUT
terminals can be adjusted.
• Microphone: Adjustment of the input volume from the
microphones of the system.
• Audio IN: Adjustment of the input volume from the
AUDIO IN terminal.
• Audio OUT: Adjustment of the output volume at the
AUDIO OUT terminal.
Using the keys on this unit
In the initial display, select "Menu" → "Settings" →
"Sound Settings" → "Volume Fine Adj".
y
• Use and to adjust each volume and
adjustment.
• Adjustment range: –12.0 dB to 12.0 dB (0.5 dB steps)
• Initial setting: 0 dB
Note
Varying the volume settings may distort audio in certain operating
environments. In this case, reduce the volume setting until the
distortion disappears.
■ Configuring the speaker mode
You can select the audio output mode from the speakers
during a call. The default setting is "Divide".
• Divide: When this unit is connected to the multiple
• Monaural: Even during a call with more than one
1 2 3
4 5 6
7 8 9
0
MIC MUTE VOL
• Small Area: The area where the audio output is heard
to confirm the
• Medium Area: The area where the audio output is
locations, the audio from other units is automatically
divided according to their locations. This mode is
indicated by on the display.
The audio from each location is divided and output
from the left/center/right side of the speaker if a
conference call involves 3 locations. If a conference
call involves 2 locations, the audio is output from the
left/right side of the speaker. As well, if a conference
call involves 1 location, it is output from the center.
location, the audio from other units is not divided
according to their locations. This mode is indicated by
on the display.
is limited to the area shown below (monaural output).
This mode is indicated by
heard is limited to the area shown below (monaural
output). This mode is indicated by
Setting the Menu List
1 2 3
4 5 6
7 8 9
0
MIC MUTE VOL
on the display.
1 2 3
4 5 6
7 8 9
0
MUTE VOL
on the display.
1 2 3
4 5 6
7 8 9
0
MUTE VOL
29