Configuring The General Settings - Yamaha PJP-100H Bedienungsanleitung

Setting the Menu List

Configuring the general settings

■ Adjusting the ring tone volume
You can adjust the ring tone volume by pressing VOL +/–.
Using the keys on this unit
In the initial display, select "Menu" → "Settings"
→"General Settings" → "Ring Volume".
■ Configuring the backlight off setting
1 2 3
4 5 6
7 8 9
0
MIC MUTE VOL
Select the time until this unit turns off the backlight
automatically when it is not engaged in a call, from
"Disable" (not to switch to standby mode), "3 minutes",
"5 minutes", "10 minutes" and "30 minutes". The default
setting is "Disable".
Using the keys on this unit
In the initial display, select "Menu" → "Settings"
→"General Settings" → "BacklightOffTime".
Using the Web menu
In the Web menu, select "BacklightOffTime".
■ Conference camera tracking control
1 2 3
4 5 6
7 8 9
0
MIC MUTE VOL
Use this feature to make the conference camera connected
to the SIRIAL terminal of this unit track and focus the
talker.
For details of this feature, consult with the nearest
YAMAHA dealer or service center.
• Disable (Default): Select this setting not to track and
focus the talker.
• Enable: Select this setting to make the conference
camera track the talker. This mode is indicated by
on the display.
Using the keys on this unit
In the initial display, select "Menu" → "Settings" →
"General Settings" → "Camera Setup" → "Camera
Tracking".
Using the Web menu
In the Web menu, select "Camera Tracking".
32
■ Initializing the conference camera
1 2 3
4 5 6
7 8 9
0
MIC MUTE VOL
Use this feature to initialize the settings of the conference
1 2 3
4 5 6
7 8 9 camera and send the conference camera parameters that
0
MIC MUTE VOL
you set on this unit.
• Yes: Select this setting to initialize the conference
camera setting.
• No (Default): Select this setting not to initialize the
conference camera setting.
Using the keys on this unit
In the initial display, select "Menu" → "Settings" →
"General Settings" → "Camera Setup" → "Restore Cam
Set".
Using the Web menu
In the Web menu, select "Camera Tracking".
■ Conference camera returning time
setting
Use this feature to set the amount of the time until the
conference camera returning to the initial position after
the room is silent.
• Return Disable: The conference camera does not
return to the initial position.
• 10 sec: 10 seconds
• 30 sec: 30 seconds
• 60 sec: 60 seconds
Using the keys on this unit
In the initial display, select "Menu" → "Settings" →
"General Settings" → "Camera Setup" → "CamReturn
Time".
Using the Web menu
In the Web menu, select "Camera Tracking".
■ Conference camera initial position
1 2 3
4 5 6
7 8 9
0
MIC MUTE VOL
Use this feature to select the initial position of the
conference camera.
Using the keys on this unit
In the initial display, select "Menu" → "Settings" →
"General Settings" → "Camera Setup" → "CamRtn
Position". Press VOL +/- to select the desired initial
position and then press
Using the Web menu
In the Web menu, select "Camera Tracking".
y
Place the camera separating from this unit by
approximately 75 cm on the side of the SIRIAL terminal.
1 2 3
4 5 6
7 8 9
0
MIC MUTE VOL
to confirm the setting.