Preparation; Preparation Procedure - Yamaha PJP-100H Bedienungsanleitung

PREPARATION PROCEDURE

The following preparation steps should be completed before using this unit.
Step 1: (page 9)
Connecting this unit to the network and turning
this unit on
↓
Step 2: (page 10)
Registering the network settings of this unit
The setting method varies depending on whether or not the
network uses a DHCP server.
↓
Step 3: (page 14)
Installing this unit in the conference room
To configure the settings from a PC
This section describes the preparation steps using the keys
on this unit, but the same settings are also available by
accessing the "Web Settings Page" from a PC. See
"Configuring the settings using the Web menu" (page 25)
for details.
Note
Some functions such as the address book setting cannot be set
using the keys on this unit alone.
To use this unit with a SIP server
The settings have to be performed by accessing the "Web
Settings Page" from a PC. See "Registering the SIP server
information" (page 37) for details.
8
Preparation Procedure
■ Notes on system connection
Please check the following before proceeding to

preparation.

LAN cable
Prepare a 10BASE-T or 100BASE-TX LAN cable.
Information on the network accommodating
this unit
When you register the network settings manually, obtain
or decide the following information prior to the
installation of this unit.
• IP address and subnet mask settings of this unit
• IP addresses of the default gateway and DNS server
Notes on the network accommodating this
unit
• When using this unit in the Internet, it is basically
• When using this unit in a corporate LAN, it cannot be
• To prevent the audio from being interrupted, it is
used by this unit
required to obtain a global IP address.
connected to equipment outside the firewall. However,
as calls may become possible by changing the settings
of the router, please consult your network administrator
for details. This unit uses a port number of 5060 (UDP)
for SIP, and 57000 to 57010 (UDP) for RTP/RTCP.
recommended that a network that can offer enough
transmission bandwidth is used. See "Specifications"
(page 55) for details.